"; _cf_contextpath=""; _cf_ajaxscriptsrc="/cfthorscripts/ajax"; _cf_jsonprefix='//'; _cf_websocket_port=8578; _cf_flash_policy_port=1244; _cf_clientid='012E3801DB6BF543377891D609D6AC88';/* ]]> */
Power Cords and Strips
14-Slot Wall-Mounted Cable Rack
9-Slot Wall-Mounted Cable Rack
US-Style (110 VAC)
Thorlabs offers a selection of power cords, power strips, and cable racks to meet your needs. The T17251 power cord is 7.5' (2.3 m) long, has US-style connectors, and is sold in packs of 5. Additionally, 12- and 24-outlet power strips with your choice of US-, EU-, or UK-style connectors are available. To view our selection of other cable types, please use the links to the right.
These 12-outlet power strips are available with US-, EU-, and UK-style outlets. Each is designed for indoor use and is housed within an impact-resistant, sturdy metal case. The units are turned on and off with a rocker switch. The power strips are fitted with clearance holes for 1/4"-20 (M6) cap screws and are shipped complete with two brackets for mounting to the rear rail of our ScienceDesks, as shown in the photo below.
The HDPS12-US Installed on the Rear Rail of One of Our ScienceDesks
These 24-outlet power strips are available with US-, EU-, and UK-style outlets. Each is designed for indoor use and is housed within an impact-resistant, sturdy metal case. The units are turned on and off using the built-in rocker switch. All power strips are fitted with clearance holes for standard 1/4"-20 or M6 cap screws.
The HDPS24-UK Power Strip is shown installed on the front of an Optical Table Shelf. It can also be installed to the underside of the shelf.
The T1508 is a test lead holder for wires up to 0.210" (5.33 mm) in diameter and has 14 slots for cables. It is ideal for holding fiber optic patch cables.
The T2708 is a test lead holder for wires up to 0.450" (11.43 mm) in diameter and has 9 slots for cables.
The cable racks are made from cold rolled steel with a baked enamel finish. The wall mounting holes are separated by 3" (76.2 mm). Both racks are 11" (279 mm) long and extend outward from the wall by 3.5" (88.9 mm).
These magnetic bases can be used to mount a 12- or 24-outlet power strip with the use of a #6 washer (not included). These bases allow the power strip to be mounted onto any magnetic surface, such as a stainless steel tabletop. The magnets offer a total mounting force of 52 lbs.
To use, slide an included cap screw with a #6 washer into one of the slots on the edge of the power strip. Slide the magnet over the screw threads and secure using an included nut. Repeat this process for the other three bases.